Our Standard Duty 0 MOA picatinny scope mounts for the bolt action Tikka T3 and Tikka T3x are made in the U.S.A. and fit all caliber Tikka T3 models. Tikka rifles produced before 2004 may require metric screws. Our HD and Hunter series mounts are machined from 6061 aluminum and are anodized for a durable finish that can withstand whatever is thrown at them.

Picatinny rails are a great addition to hunting rifles and precision rifles. Picatinny scope mounts allow you to use weaver or picatinny rings. There are multiple advantages of a one piece base over a two piece base or dovetail rings. One of the advantages is a one piece base increases accuracy by keeping the rings precisely aligned. Another advantage is a one piece picatinny base allows the user to quickly exchange optics between hosts, due to the standardized spacing of picatinny spec.

Metric screws are only available with hex heads. Check out the Tikka FAQ page here for more info.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.