EGW HD 30 MM Tactical Aluminum Rings 1.275"
Blue Loctite
HD Tikka T3X Tac A1 Picatinny Rail 30 MOA
Irwin Hanson 585-1221 Bottoming Tap 6-48
Replacement Set of Torx Screws w/ Bit for EGW Picatinny Mounts
This product fits:
You may need to use a 1/32" washer as a shim between the front of the rail and the handguard when tightening the handguard to the rail.
Unleash unparalleled accuracy and performance with the HD Tikka T3X Tac A1 Picatinny Rail 20 MOA. This precision-engineered rail is specifically designed to elevate your Tikka T3x Tac A1, enabling enhanced long-range shooting capabilities. Whether you're engaged in competitive shooting, hunting, or tactical operations, this rail sets the foundation for unmatched precision and reliability.
Specifications
Rail Type: One Piece Picatinny
Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Hardcoat
Center Spread: 3.245"
Overall Length of Mount: 6.761"
Height: .35" (Top of Receiver to Top of Picatinny)
Weight: 2.5 oz
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: (5) #6-48 X 1/4 Screws, (2) Recoil Pins, and T-10 Wrench Included
Torque Specs: 20 in/lbs
There is a screw in the front of the original mount that is located underneath the handguard. The handguard must be removed and then this screw must also be removed before the original mount can be removed.
Removing the original mount may be a difficult task. Please use caution when removing the original mount and when installing our mount. Please refer to our video above for mounting instructions. We always recommend having our products installed by a competent and qualified gunsmith.
Metric screws are only available with hex heads. Check out the Tikka FAQ page for more info.
We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability.
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.