Machined From: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Only
Mounting Hardware: Hex Head Screws and Wrench Provided
Center Spread: 4.275"
Overall Length of Mount: 6.670"

*The center spread is the distance between the two middle holes, center to center, on your receiver.

TThis scope mount is made for Mausers with the stripper clip hump.

Our Mauser 98 scope mount does not fit the 3000 L.

This base sits at approximately 0.4” high.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.