This mount fits:

• Savage Model 110 Long Action Flat Rear Receiver
• Savage Model 111 Long Action Flat Rear Receiver
• Savage Model 112 Long Action Flat Rear Receiver
• Savage Model 114 Long Action Flat Rear Receiver
• Savage Model 116 Long Action Flat Rear Receiver
• Stevens Model 200 Long Action Flat Rear Receiver

Specifications

Rail Type: One Piece Picatinny
Machined from: Domestic Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Only
Center Spread: 4.630"
Overall Length: 7.458"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: Yes
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

Our Savage bases will work with any long action round back Savage rifle with an ejection port. It is also compatible with the Stevens Long actions.

The flat back on this mount will accommodate receivers with flat rears, and guns that do not have an accu-trigger.

Savages with an accu-trigger will require our round back mount (listed separately).

This mount comes standard with a bevel on both sides making it ambidextrous.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type III anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.