Mounting Hardware is Included

This mount fits:
Winchester 70 Pre 64' All Calibers
Winchester 70 Post 64' Long Action
Winchester Model 670
Marlin XL7
Sears Model 53
Ted Williams Model 53

*The Winchester Coyote edition chambered in .243 will require our WSM mount.*

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 3.805"
Overall Length: 7.064"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

We manufacture the best picatinny rail scope mounts for the Winchester Model 70. The mount is specifically for the Winchester Model 70 pre-64 standard action and post-64 long action and has 0 MOA cant. We also offer picatinny rails Model 70 short action, WSM, and WSSM.
*The Winchester Model 70 Coyote edition chambered in .243 will require our WSM mount.*

The middle spread is the distance between the two middle holes, center to center, on your receiver. The middle spreads on our Winchester model 70 picatinny rail mounts are as follows:

Winchester 70 Short Action: 3.259"
Winchester 70 Long Action: 3.805"
Winchester 70 WSM: 3.514"
Winchester 70 WSSM: 3.225"

This mount comes standard with a bevel on both sides making it ambidextrous.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.