Mounting Hardware is Included

This mount fits:
Kimber 82C
Kimber 82G
H&R M12
Winchester 75
BSA Martini Mk2
BSA Martini MK3
Remington 37

This mount will only work with Anschutz 64 if has the Unertl barrel blocks.

Our Winchester 52 mount is made specific to the gun. This mount is available in 0, 20 and Negative 20 MOA.

If your Winchester has a TAPERED BARREL (very front of the barrel measures less than .750" , you will need this negative 20 MOA rail. The tapered barrel automatically gives you a 20 MOA, the negative will bring you back to 0 MOA.

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: .860"
Overall Length: 5.882"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
Barrel Taper (Win 52): Yes, The End of My Barrel Measures Less Than .750"

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-150 yards
20 MOA - if shooting 150-300 yards

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.