HAVE AN AIMPOINT ACRO? USE THIS PLATE TO ADAPT THE DOCTER FOOTPRINT TO THE AIMPOINT ACRO FOOTPRINT

Smith & Wesson M&P Red Dot Mount | Fits Vortex Venom, Viper, Burris FastFire & Docter

The EGW red dot sight mount adapter plate for Smith & Wesson M&P pistols is designed to replace the factory rear sight and provide a low-profile mounting solution for optics using the Docter / Vortex / Burris FastFire footprint.

Our red dot mounts are designed to install from left to right with the muzzle facing forward. The dovetail has a progressive taper to allow for easier installation and proper fitment.

Due to manufacturing tolerances between firearms, minor fitting may be required.

Learn more about optic footprints: RMR vs Docter vs RMSc Footprints Guide

This Mount Fits:

• Smith & Wesson M&P Full Size
• Smith & Wesson M&P 2.0 Full Size
• Smith & Wesson M&P 22 Full Size
• Smith & Wesson M&P Compact
• Smith & Wesson M&P 2.0 Compact
• Smith & Wesson SD9VE
• Smith & Wesson SD40VE
• Smith & Wesson M&P Shield
• Gen 1 Tisas (Zigana) PX9

This Mount Does NOT Fit:

• Smith & Wesson M&P C.O.R.E Series (Already optics ready)
• Smith & Wesson M&P Shield EZ .380
• Smith & Wesson M&P Shield EZ 9mm
• Smith & Wesson M&P .22 Compact
• Smith & Wesson SW9VE
• Smith & Wesson SW40VE
• Smith & Wesson Bodyguard 2.0

Mounting Hardware Included

• (2) 6-32 x 3/8 Flat Head Cap Screws
• (1) 6-32 x 3/16 Cup Point Set Screw
• (2) 6-32 x 5/16 Button Head Screws

Compatible Red Dots

• Viridian RFX25
• Vortex Viper
• Vortex Venom (Open Emitter)
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

Installation Instructions

• Remove the factory rear sight
• Install the EGW Sight Mount in the dovetail
• Tighten set screw if applicable
• Place the red dot sight on the EGW mount
• Apply blue Loctite to the provided mounting screws
• Torque mounting screws to 15 in/lbs

The screws included with this mount require a 5/64" Allen wrench for installation.

Why Choose This Smith & Wesson M&P Red Dot Mount?

• ✔ No permanent slide modification required
• ✔ Low-profile rear sight replacement design
• ✔ Precision machined from 7075 aluminum
• ✔ Compatible with popular Docter footprint optics
• ✔ Progressive taper dovetail for improved installation
• ✔ Made in the USA by EGW

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Click here to see a video from Vortex on how to install our red dot base on a slide.