Mounting Hardware is Included

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This EGW Mount for Glock - for the Vortex Venom will fit all generation listed below:

• Glock 17
• Glock 17L
• Glock 19
• Glock 19x
• Glock 20
• Glock 21
• Glock 22
• Glock 23
• Glock 24
• Glock 26
• Glock 27
• Glock 29
• Glock 30
• Glock 30 SF
• Glock 31
• Glock 32
• Glock 33
• Glock 34
• Glock 35
• Glock 36 (Our mount is wider than the slide, but it will still work)
• Glock 37
• Glock 38
• Glock 39
• Glock 41
• Glock 42 (Our mount is wider than the slide, but it will still work)
• Glock 43 (Our mount is wider than the slide, but it will still work)
• Glock 43x (Our mount is wider than the slide, but it will still work)
• Glock 44
• Glock 45
• Glock 46
• Glock 48 (Our mount is wider than the slide, but it will still work)
• Canik TP9 SF
• Canik TP9 SA
• Bersa BP9CC
• Tactical Solutions .22lr Conversion
• Taurus G3c
• Taurus GX4 (non optic ready slide)
• Advantage Arms .22lr Conversion
• PSA Dagger (NON-optics ready)

Does not fit Glock MOS models.

• Glock 17 Gen 4 MOS
• Glock 19 Gen 4 MOS
• Glock 34 Gen 4 MOS
• Glock 35 Gen 4 MOS
• Glock 40 Gen 4 MOS
• Glock 41 Gen 4 MOS
• Glock 22 Gen 5 MOS
• Glock 23 Gen 5 MOS
• Glock 34 Gen 5 MOS
• Glock 45 MOS
• Glock 43x MOS
• Glock 48 MOS

WILL NOT WORK WITH ANY CANIK THAT HAS A STEPPED REAR  SIGHT CUT

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.