UNDRILLED Savage 93 and Mark II with 1-5/8" Ejection Port Picatinny Rail 20 MOA

Mounting Hardware is Included

This mount is not drilled. We have found some receivers have hole spacing that is a little out of spec. We made this mount so the end user could drill the holes to match their receiver. If your receiver is drilled and tapped and matches the hole spacing we have listed on the regular mount, you should be able to use that mount.

This mount fits:
Savage 93 (All models)
Savage MK II with 1-5/8" ejection port
Stevens 310

Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: Undrilled
Overall Length: 5.882"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

*Please note, older Savage MK II rifles come with a 1-3/8" ejection port and utilize our Savage MK II scope mounts. Please measure the size of your ejection port prior to ordering to ensure the right fit.*

Here is a great article from Savage Shooters about the differences between older and newer model MK II rifles.

This mount comes standard with a bevel on both sides making it ambidextrous.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-150 yards
20 MOA - if shooting 150-300 yards

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.