EGW Remington 1100/1170/1187 Picatinny Rail Scope Mount

Mounting Hardware is Included:

This mount fits:

• Remington 1100
• Remington 1187
• Remington V3
• Remington Versa Max
• V3 / Versa Max - Our .335" Overall Length Screws work in all 4 holes
• 1100 / 1187 / 870 - .313" Overall Length Screws for all 4 holes
  
  We have found that some models are not drilled and tapped from the factory. If that is the case, you would need to have your receiver drilled and tapped before installing our mount. If you have any questions about your specific model or receiver, we recommend contacting the manufacturer of your firearm. They should be able to confirm whether your receiver is drilled and tapped by referencing your serial number.

Rail Type: One Piece Picatinny
Machined From: Domestic 6061 T6 Extruded Aluminum
Finish: Matte Black Anodizing
Center Spread: 1.475"
Overall Length: 5.488"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.