Mounting Hardware is Included

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This Mount Fits:

• Baby Desert Eagle (Post 2006)
• EAA Witness Elite Match (Please confirm your rear sight with the images above)
• EAA SAR K2P 9mm (Please confirm your rear sight with the images above)
• Newer Jericho 941

This mount does not fit:

• Rock Island 1911s
• EAA / Tanfoglio Witness' with LPA/Bomar style rear sights (EAA Super Sight)

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Dovetail Width: .478"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw

Red Dot Fitment:

   
• Vortex Defender Series (Defender XL requires the screws provided by Vortex)
• Vortex Venom (Enclosed Red Dot)
• OSight SE
• Bushnell RXS-100   
• Crimson Trace CTS-1500   
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*   
• Holosun EPS-RD*   
• Holosun EPS-Carry-GR*   
• Holosun EPS-Carry-RD*   
• Jpoint   
• Leupold Delta Point Pro   
• Optima   
• Redfield Accelerator   
• Shield RMS  
• Shield RMSc   
• Shield SMS   
• Sig Romeo Zero

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.