Mounting Hardware is Included
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
This Mount Fits:
- Elite Stock II with adjustable (LPA/Bomar style, shown above) rear sight
- Elite Stock III with adjustable (LPA/Bomar style, shown above) rear sight
- Hunter with adjustable (LPA/Bomar style, shown above) rear sight
- Limited Custom with adjustable (LPA/Bomar style, shown above) rear sight
- Limited Custom Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- Match Elite with adjustable (LPA/Bomar style, shown above) rear sight
- Match Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- P Match with adjustable (LPA/Bomar style, shown above) rear sight
- P Match Pro with adjustable (LPA/Bomar style, shown above) rear sight
- Stock II Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- Stock III Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
- Tanfoglio | Defiant Force 22
This mount does not fit:
- EAA / Tanfoglio Witness with fixed rear sight
- EAA / Tanfoglio Witness with Novak style adjustable rear sight, shown above
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Overall Height: .335"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment:
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.
