We desiged the .100" gap bushing to service those that have a gap between their slide and the bushing. On a normal slide a lug gap of .117" is considered standard. Some slides have a gap of only .105:, so a normal bushing left a gap of .012" between the bushing and the slide. To correct this problem, we have moved the lug closer to the flange tightening the gap.

This bushing is stainless steel.

Our Carry Bevel bushing is machined from solid barstock steel.

The flange thickness is .125" which protects the barrel more because it sticks out farther than the spec bushing.

Available in Stainless Steel and blued Carbon Steel.

Gunsmith Fit is available in all O.D.'s with a .568" I.D. Straight Bore.

O.D. of the bushing = Inside diameter of your slide - usually .699" - .705";
I.D. of the bushing = Outside diameter of your barrel - usually .575" - .583".

Please measure these two areas with calipers to find the sizes you need.
Please select your options carefully.

Please provide exact measurements, as our machinist will allow for clearance.

Check out our FAQ Section for instructions on how to accurately take these measurements.
Angle Bore is bored on an angle or a snug fit (measurements must be precise);
Straight Bore is bored straight without variation.

Please allow 3 weeks for custom bored bushings.

When choosing a spring plug, choose the EGW Long Nose Spring Plug for a flush fit!