Mounting Hardware is Included

This is a press fit mount. Utilization of a sight pusher tool may be required.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This mount fits:

• Walther PPQ Classic (M1)
• Walther PPQ M2 (All models except optics ready and .22lr)
• Walther PPQ 45
• Walther PPQ 45 SD
• Walther PPQ Sub Compact
• Walther P99 (All Models)
• Walther PPX (All Models)
• Walther Creed
• Walther Creed 10 Round
• Walther PPS (All Models)
• Walther PPS M2 (All Models)

This mount does not fit:

• Walther PPQ 22
• Walther PPQ Q4 Tac (optics ready)
• Walther Q5 Match (optics ready)
• Walther Q5 Match SF Arabesque
• Walther Q5 Match SF Patriot
• Walther Q5 Match SF Black Diamond
• Walther Q5 Match SF Match Black Tie
• Walther P2

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs

Mounting Hardware:
(2) 6-32 Button Head Screws
(2) 6-32 Flat Head Screws

Red Dot Fitment:

• Viridian RFX25
• Vortex Viper
• Vortex Venom ( Not Enclosed )
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Click here to see a video from Vortex on how to install our red dot base on a slide.