This is a press fit mount. Utilization of a sight pusher tool may be required.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (2) 6-32 Flat Head Screws, (1) 6-32 Set Screw

Red Dot Fitment:

• Viridian RFX25
• Vortex Viper
• Vortex Venom
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

This Evolution Gun Works - EGW Springfield XD Red Dot Mount:

• Springfield XD® MOD.2® – 3" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 3.3" SUB-COMPACT MODEL
• Springfield XD® MOD.2® – 4" SERVICE MODEL
• Springfield XD® MOD.2® – 4" SERVICE MODEL THREADED BARREL
• Springfield XD® MOD.2® – 5" TACTICAL MODEL
• Springfield XD® 3" SUB-COMPACT MODEL
• Springfield XD® 4" SERVICE MODEL
• Springfield XD(M)® 3.8" COMPACT MODEL
• Springfield XD(M)® 3.8" MODEL
• Springfield XD(M)® 4.5" MODEL
• Springfield XD(M)® 4.5" THREADED BARREL MODEL
• Springfield XD-S® 3.3" MODEL
• Springfield XD-E™ 3.3" SINGLE STACK
• Springfield XD-E™ 3.8" SINGLE STACK
• Springfield XD-E™ 3.8" SINGLE STACK
• Springfield Hellcat (NON OSP - NOT OPTIC READY)

Does not fit:

• Springfield XD(M)® 5.25" COMPETITION SERIES MODEL
• Any Optics Ready Springfield XD

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.  

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.