HAVE AN AIMPOINT ACRO? USE THIS PLATE TO ADAPT THE DOCTOR FOOTPRINT TO THE AIMPOINT ACRO FOOTPRINT

The EGW red dot sight mount adapter plates for the Sig Sauer P365 Optics Ready pistols are meant to be installed in place of the factory mounting plate. Simply remove the sight plate on your gun and replace it with our mount in order to mount your Vortex Viper, Vortex Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Mounting Hardware is Included

This mount fits:
Sig Sauer P365X Optics Ready
Sig Sauer P365XL Optics Ready
Sig Sauer P365 Optics Ready With Fixed Rear Sight & Loaded Chamber Indicator

This mount does not fit:
Sig Sauer P365 SAS
Sig Sauer P365 XMACRO
Sig Sauer p322 (optics ready)

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs

Mounting Hardware Included:
(2) 6-32 x 5/16" Button Head Screws - Requires 5/64 Wrench or Driver
(2) 6-32 x 3/8" Flat Head Screws - Requires 5/64 Wrench or Driver
(2) M3 x .5 x 8mm Flat Head Screws - for mounting the plate to the slide - Requires use of 2mm Hex Key

Red Dot Fitment:

• Viridian RFX25
• Vortex Viper
• Vortex Venom
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

Installation Instructions
- Remove the rear sight plate*
- Install the EGW Sight Mount on the slide
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Click here to see a video from Vortex on how to install our red dot base on a slide.