Blue Loctite
Blue Loctite
Vortex Optics Venom 6 MOA Red Dot Sight
Vortex Optics Venom 6 MOA Red Dot Sight
This mount does not work on any optics ready Sigs.
Mounting Hardware is Included
This mount is oversized by .010" and is meant to be used with slides that are cut oversized.
This mount fits (including but not limited to):
Sig #8 Sights
P210A Standard
P220
P224
P225
P225-A1
P226
P227
P228
P229
P238
P239
P245
P320
P938
SP2022
M11-A1
MK25
Bersa Thunder UC Series (9/40/45)
Bersa Thunder HC Series (9/40/45)
FN 509
This mount does not fit:
Sig 1911s
Sig P220 10mm Hunter
Any Optics Ready Sigs i.e. P226 Legion RX, P229 RX, P320 X-Carry etc.
P210 Target
P365 (The dovetail cut is too deep to work with our mount)
FN 509 Tactical
Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs
Mounting Hardware:
(2) 6-32 Button Head Screws
(2) 6-32 Flat Head Screws
(1) 6-32 Set Screw
Red Dot Fitment:
Vortex Viper
Vortex Venom
Burris Fast Fire 1, 2, 3, 4
Docter
ADE RD3-001
ADE RD3-002
ADE RD3-009
UTG Reflex Micro Dot
Crimson Trace CTS-1200
Crimson Trace CTS-1300
Sightmark Mini Shot
Sightmark Core Shot
Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.
Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Viper/Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.
This is a press fit mount. Utilization of a sight pusher tool may be required.
Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs
2 Button Head Cap Screws - Provided for Vortex Viper and Venom Sights
2 Flat Head Cap Screws - Provided for Burris FastFire and Docter Sights
The screws that are included with this mount require a 5/64'' allen wrench for installation.
WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.
Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.