This mount fits:

• Ruger Max-9

EGW's red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs

Mounting Hardware:
(2) 6-32 x 5/16" Button Head Screws - Requires 5/64 Wrench or Driver
(2) 6-32 x 3/8" Flat Head Screws - Requires 5/64 Wrench or Driver
(2) M4 x .7 x 8mm Flat Head Cap Screws - for mounting the plate to the slide - Requires use of 2.5mm Hex Key

Red Dot Fitment:

• Viridian RFX25
• Vortex Viper
• Vortex Venom
• Burris FastFire
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

The EGW red dot sight mount adapter plates for the Ruger Max-9 are meant to be installed in place of the factory mounting plate. Simply remove the sight plate on your gun and replace it with our mount in order to mount your Vortex Viper, Vortex Venom, Burris FastFire, or Docter red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the mounting plate cover
- Install the EGW Sight Mount on the slide
- Torque mounting screws to 15in/lbs
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

(2) 6-32 Button Head Screws - Requires use of 5/64" Hex Key Provided for Vortex Viper and Venom Sights
(2) 6-32 Flat Head Screws - Requires use of 5/64" Hex Key Provided for Burris FastFire and Docter Sights
(2) M4 x .7 x 8mm Flat Head Cap Screws - for mounting the plate to the slide - Requires use of 2.5mm Hex Key

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Click here to see a video from Vortex on how to install our red dot base on a slide.