HAVE AN AIMPOINT ACRO? USE THIS PLATE TO ADAPT THE DOCTER FOOTPRINT TO THE AIMPOINT ACRO FOOTPRINT

Walther PPQ 22 Red Dot Mount | Fits Vortex Venom, Viper, Burris FastFire & Docter

The EGW red dot sight mount for the Walther PPQ M2 .22LR installs in place of the factory rear sight and provides a low-profile mounting solution for optics using the Docter / Vortex / Burris FastFire footprint.

This mount allows you to install optics like the Vortex Venom (Open Emitter), Vortex Viper, Burris FastFire, Viridian RFX25, and other compatible micro red dots without permanent slide modification.

The mount installs from left to right with the muzzle facing forward. The dovetail uses a progressive taper for easier installation and secure fitment.

Learn more about optic footprints: RMR vs Docter vs RMSc Footprints Guide

Compatible Pistols

• Walther PPQ M2 .22LR (PPQ 22)

Does NOT Fit

• Walther PPQ M2 centerfire models
• Walther PPQ Q4 Tac
• Walther Q5 Match
• Walther P22

Any Walther model that comes with the standard sights that use the detent setup may work with this mount. This mount now includes a set screw allowing it to be used with friction-fit dovetails as well.

Compatible Red Dots

• Viridian RFX25
• Vortex Viper
• Vortex Venom (Open Emitter)
• Burris FastFire 1
• Burris FastFire 2
• Burris FastFire 3
• Burris FastFire 4
• Docter
• ADE RD3-001
• ADE RD3-002
• ADE RD3-009
• UTG Reflex Micro Dot
• Crimson Trace CTS-1200
• Crimson Trace CTS-1300
• Sightmark Mini Shot
• Cuda RX-795

Mounting Hardware Included

• (2) 6-32 x 5/16 Button Head Screws
• (2) 6-32 x 3/8 Flat Head Cap Screws
• (1) 6-32 x 3/16 Cup Point Set Screw

Installation Notes

• Remove the factory rear sight
• Install the EGW mount into the dovetail from left to right with the muzzle facing forward
• Tighten set screw if applicable
• Place the optic onto the EGW mount
• Apply blue Loctite to the optic mounting screws
• Torque optic mounting screws to 15 in/lbs

Why Choose This Walther PPQ 22 Red Dot Mount?

• ✔ No permanent slide modification required
• ✔ Low-profile rear sight replacement design
• ✔ Compatible with popular Docter footprint optics
• ✔ Precision machined from durable 7075 aluminum
• ✔ Lightweight and rugged for training or range use
• ✔ Proudly made in the USA by EGW

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.

Click here to see a video from Vortex on how to install our red dot base on a slide.