This mount fits:
Walther PPQ .22LR

This mount does not fit:
Walther PPQ M2
Walther PPQ Q4 Tac (already optics ready)
Walther Q5 Match (already optics ready)
Walther P22

Our Walther PPQ 22 red dot sight adapter plates for the Vortex Razor are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Vortex Razor, C-More RTS or STS red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.