Mounting Hardware is Included

This mount fits:

• Walther PPQ M2 .22LR (PPQ 22)

This mount does not fit:

• Walther PPQ M2 (pistol calibers other than 22lr)
• Walther PPQ Q4 Tac (already optics ready)
• Walther Q5 Match (already optics ready)
• Walther P22

Any Walther model that comes with the standard sights that have the detent will work with this mount. This mount now comes with a set screw allowing it to be used with the friction fit dovetails as well.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.78"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Our Walther PPQ 22 red dot sight adapter plates for the Trijicon RMR / SRO and Holosun 407c / 507c are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.