This mount fits:

• Savage 301 (Factory Drilled and Tapped 12 and 20 Gauge only)
• Stevens 301 (Factory Drilled and Tapped 12 and 20 Gauge only)

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

This mount does not fit:

• Stevens 301 .410 models

Specifications

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Thickness Above Receiver: .350"
Torque Specs: 15 in/lbs

Mounting Hardware:
(2) 6-32 Button Head Screws - Requires 5/64 Wrench or Driver
(2) 6-32 Flat Head Screws - Requires 5/64 Wrench or Driver
(2) 8-40 Torx Screws - Requires T10 Wrench or Driver

Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the factory mount and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your original mount at any time. Mounting hardware included.

Installation Instructions
- Remove the factory mount
- Install the EGW Sight Mount on the raised interface
- Secure the plate to the barrel of the gun with the provided screws and torque to 20 in/lbs
- Place the red dot sight on the EGW Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided red dot mounting screws
- Torque red dot mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.