Mounting Hardware is Included

This mount fits:

• Elite Stock II with adjustable (LPA/Bomar style, shown above) rear sight
• Elite Stock III with adjustable (LPA/Bomar style, shown above) rear sight
• Hunter with adjustable (LPA/Bomar style, shown above) rear sight
• Limited Custom with adjustable (LPA/Bomar style, shown above) rear sight
• Limited Custom Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
• Match Elite with adjustable (LPA/Bomar style, shown above) rear sight
• Match Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
• P Match with adjustable (LPA/Bomar style, shown above) rear sight
• P Match Pro with adjustable (LPA/Bomar style, shown above) rear sight
• Stock II Xtreme with adjustable (LPA/Bomar style, shown above) rear sight
• Stock III Xtreme with adjustable (LPA/Bomar style, shown above) rear sight

This mount does not fit:

• EAA / Tanfoglio Witness with fixed rear sight
• EAA / Tanfoglio Witness with Novak style adjustable rear sight, shown above

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.780"
Overall Width: 1.1"
Mounting Hardware: (2) 6-32 Flat Head Screws, (1) 6-32 X 3/16 Set Screw
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

2 Flat Head Cap Screws - Provided for Trijicon RMR

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.