Mounting Hardware is Included

This mount fits:

• Walther Q4 Steel Frame OR
• Walther Q4 Tac M1
• Walther Q4 Tac M2
• Walther Q5 Match M1
• Walther Q5 Match M2
• Walther Q5 Match Steel Frame Standard
• Walther Q5 Match Steel Frame Potential
• Walther Q5 Match Steel Frame Standard 10RD

This mount does not fit:

• Walther Q5 Match SF Arabesque
• Walther Q5 Match SF Patriot
• Walther Q5 Match SF Black Diamond
• Walther Q5 Match SF Match Black Tie
• Walther PDP

Please note: Trijicon recommends the use of a sealing plate to prevent water from entering their red dots.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.968"
Overall Width: .99"
Torque Specs: 15 in/lbs
Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Trijicon RMR red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

The screws that are included with this mount require a 5/64'' allen wrench for installation.

Click here to see a video from Vortex on how to install our red dot base on a slide.