Our HK VP9 Red Dot Adapter Plate is comparable to the HK #2 adapter plate, but is made in house from aluminum. Simply remove the plate on your HK VP9 Optics Ready or VP9L Optics Ready and replace it with our mount in order to mount your Trijicon RMR, SRO, Holosun 407c, 507c red-dot sight. You can take our mount off and replace your rear sight at any time. The hardware to install the red dot to our optics plate is included. We do not include the hardware to install the plate to the slide, but that can be purchased as an add-on.

Mounting hardware is included.

This mount fits:

• HK VP9 Optics Ready Models

(This mount is comparable to the HK VP9 Optics Ready #2 Plate)

The screws that come with your slide to mount the plate to the slide may be reused. They are also available for purchase from the drop down above. HK recommends replacing the plate mounting screws after 2,000 rounds. HK recommends torquing the screws for the plate to 2Nm or 17.7 in/lbs.

The screws to mount the red dot to the plate are provided at no extra cost. We recommend using 15 in/lbs.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.811"
Overall Width: .99"
Torque Specs: 15 in/lbs

Mounting Hardware:
(2) 6-32 Button Head Screws
(2) 6-32 Flat Head Screws

Red Dot Fitment: Trijicon RMR / SRO, Holosun HE407C / HE507C / HS407C / HS507C, Swampfox Kingslayer / Liberty / Justice

This mount fits the HK VP9 Optics Ready Models.

Installation Instructions
- Remove the rear cover plate
- Install the EGW sight mount and torque the mounting plate screws
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque red dot mounting screws to 15in/lbs