EGW Remington 700, 722, 40x Short Action 20 MOA Picatinny Rail Scope Mount
This mount fits:
- Remington 700 Short Action
- Remington 700 Ultimate Muzzleloader
- Remington 722 Short Action
- Remington 40X Short Action
- Bergara B14 (#6 Screws)
- Christensen Arms Short Action listed below
- Early Ridgeline - Based on Savage Action Serial Numbers Starting With CB Lower Than CB00909 #6-48 Screws
- Later Ridgeline - Based on Remington 700 Actions Serial Numbers Starting With CV #6-48 Screws
- Mesa - Based on Remington 700 Actions Serial Numbers Starting With CV #6-48 Screws
Rail Type: One Piece Picatinny
Machined from: Domestic 6061 T6 Extruded Aluminum
Finish: Silver Anodizing
Center Spread: 3.627"
Overall Length: 6.276"
Height: .4" (Top of Receiver to Top of Picatinny)
Weight: 2 oz.
Quick Disconnect Ring Compatible: No
Ambidextrous: Yes
Torque Specs: 20 in/lbs
Mounting Hardware: #6-48 X 1/4 Screws and T-10 Bit Included
The Bergara Premier, and certain Remington 700 models (ie. 700 Police, 700 LTR) require the base to be drilled out for #8 screws. Our Remington 700 mounts that are predrilled are only available in our Heavy Duty platform and are available below. If you would like to drill the mount yourself, we do offer a #8 Drill Out Kit which comes with the appropriate drill bit and screws.
Remington Short Action Mounts Drilled for #8 Screws:
0 MOA
20 MOA
This mount comes standard with a bevel on both sides making it ambidextrous.
The bolt pattern on our Remington 700 Short Action mount fits Short Action Remington 700 rifles (example 223, 308), as well as the 722 and 40x. Despite what you may have heard, the Remington 700 mount will NOT fit your Howa 1500 or Weatherby Vanguard. The bolt pattern is similar, but the remainder of the mount (ejection port, length, etc.) renders it useless on these two guns.
We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.
Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.
We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.
Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).
We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards
When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.
The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.
Warning: This product may be alloyed with trace amounts of lead and other elements which are known to the State of California to cause reproductive harm and cancer. To prevent exposure, do not alter the product by welding, grinding, etc. For more information, go to www.P65Warnings.ca.gov.