Our Hunter Series and Heavy Duty mounts now all come with #6 and #8 screws. They are available here.

This mount is drilled for and provided with 6-48 Torx Head and 8-40 Torx Head Screws.

This mount fits:
Savage Model 10 with AccuTrigger Short Action Round Rear Receiver
Savage Model 11 with AccuTrigger Short Action Round Rear Receiver
Savage Model 12 with AccuTrigger Short Action Round Rear Receiver
Savage Model 14 with AccuTrigger Short Action Round Rear Receiver
Savage Model 16 with AccuTrigger Short Action Round Rear Receiver
Savage Model 110 with AccuTrigger Short Action Round Rear Receiver
Stevens Model 200 Short Action Round Rear Receiver

Rifles requiring #8 screws (please check your individual rifle to be sure):
Savage Model 10/110 BA Stealth
Savage Model 10/110 Stealth Evolution
Savage Model 10 GRS
Savage Model 110 Ridge Warrior
Savage Model 110 Scout
Savage Model 110 Tactical
Savage Model 110 Tactical Desert
Savage Model 110 Tactical LH
Savage Model 110 Timberline
Savage Model 110 Ultralite
Savage Model 110 Wolverine
Christensen Arms Ridgeline (Please Check Your Serial Number Here)

Screw Diameters
#6 Screws - .13" diameter
#8 Screws - .16" diameter

This Savage base will work with any short action round back Savage rifle with an ejection port. It is also compatible with the Stevens short actions.

The round back on this mount will accommodate rounded receivers, and guns that have an accu-trigger. Savages without an accu-trigger will require our flat back mount (listed separately).

This mount comes standard with a bevel on both sides making it ambidextrous.

We recommend measuring the hole spacing in your receiver to confirm it matches with the dimensions we have published.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount. Also, in many cases, it will not obstruct usage of factory iron sights. Our one-piece scope mounts are the obvious choice for hunters and tactical shooters alike.

We machine these in our shop using one of our machining centers. After machining, the mounts are tumbled, sand blasted, and Type II anodized for long lasting durability.

Installation: We recommend 20 inch lbs of torque and a drip of blue loctite (loctite is available through our website and is sold separately).

We recommend:
0 MOA - if shooting 0-500 yards
20 MOA - if shooting 500-1000 yards

When zeroing your rifle with a 20 MOA mount, we recommend zeroing at 200 yards.

The entire mount and accessories (from the mounting screws and wrench down to the packaging) are made in the USA.

Picatinny rails are commonly misspelled as to as:
picitinny rail
picatiny rail
picitanny rail
pickitini rail
pitcanny rail
picaninny rail
picanty rail