Best way to achieve a custom tight fit to prevent extractor clocking. Also maintaining the low radius changes the recoil pulse slightly slowing the slide down making for faster follow up shots and increasing reliability in the 1911 design. I use the EGW oversized firing pin stops in all my 1911s.

For sure oversized, took about a hour to dial in the fit but now it’s perfect. So if you are in for a character building exercise and want an exact fit look no further

High quality piece, machined to a high tolerance. It required minor fitting- which it should. Would buy again.

A must have for the 1911 in 10mm

fit with very little honing

A very high-quality part. I like that the stop is now supplied with a small radius already cut on the bottom corner.

Perfect! After some minor fitting, there is no extractor clocking and my brass is not flying across the range.

I was able to file the stop to make perfect fit into the extractor groove. No more extractor clocking.