This Mount fits:

• Vortex Spitfire HD Gen II 5x

Does NOT work with RMRcc

Specifications

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.95"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Flat Head Screws to mount the red dot to the plate

Red Dot Fitment:
Bushnell RXS-100
Crimson Trace CTS-1500
Holosun 407K*
Holosun 407k-GR
Holosun 507K*
Holosun 507k-GR
Holosun EPS-GR*
Holosun EPS-RD*
Holosun EPS-Carry-GR*
Holosun EPS-Carry-RD*
Jpoint
Leupold Delta Point Pro
Optima
Redfield Accelerator
Shield RMS
Shield RMSc
Shield SMS
Sig Romeo Zero

Simply remove the plate on your HD Spitfire Gen II 5x and replace it with our mount in order to mount your Holosun K Series. You can take our mount off and replace the cover plate at any time. Red dot mounting hardware included.

Installation Instructions
- Remove the cover plate
- Install the EGW sight mount and torque the mounting plate screws
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque red dot mounting screws to 15in/lbs

*When re-using the factory cover plate screws, some customers have run into issues with them bottoming out. We have found that the bottom finger of the helicoil inside the theads on the spitfire may be contacting the screw, preventing it from threading in all the way.  If you carefully push the finger down and to the side, that should allow the screw to thread all the way in. You can also remove about .010" of material from the bottom of the screw to allwo it to seat.