Mounting Hardware is Included

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

This mount fits:
Walther PPQ Classic (M1)
Walther PPQ M2 (All models except optics ready and .22lr)
Walther PPQ 45
Walther PPQ 45 SD
Walther PPQ Sub Compact
Walther P99 (All Models)
Walther PPX (All Models)
Walther Creed
Walther Creed 10 Round
Walther PPS (All Models)
Walther PPS M2 (All Models)

This mount does not fit:
Walther PPQ 22
Walther PPQ Q4 Tac (optics ready)
Walther Q5 Match (optics ready)
Walther Q5 Match SF Arabesque
Walther Q5 Match SF Patriot
Walther Q5 Match SF Black Diamond
Walther Q5 Match SF Match Black Tie
Walther P2

*For this mount to work with the Holosun 407K and 507K, the rear pins on the mount MUST be removed by milling or filing.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws

Red Dot Fitment:

• Vortex Defender Series
• OSight SE
• Bushnell RXS-100
• Crimson Trace CTS-1500
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*
• Holosun EPS-RD*
• Holosun EPS-Carry-GR*
• Holosun EPS-Carry-RD*
• Jpoint
• Leupold Delta Point Pro
• Optima
• Redfield Accelerator
• Shield RMS
• Shield RMSc
• Shield SMS
• Sig Romeo Zero

Any Walther model that comes with the standard sights that have the detent will work with this mount. This mount now comes with a set screw allowing it to be used with the friction fit dovetails.

The PPQ sight has a hole drilled in the bottom of the dovetail to accomodate the plunger on some models of the Walthers.

Our red dot sights are meant to be installed from the left to the right (with the muzzle facing forward). The dovetail has a progressive taper to allow for easier install.

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.