Mounting Hardware is Included

This Mount Fits:

• Sig P210A Target

This mount for the P210 is made specifically for the U.S. made P210s. The front of the mount will need to be cross drilled to fit each individual gun. The pin from the factory rear sight may be reused as well.

The hole dimension for the cross hole is 2.04mm. There are 2.04mm drill bits available from sites like Grainger, but you may also be able to use a 5/64" bit to mark the hole on the mount and a 3/32" bit to drill the hole. Sig uses a 2mm coiled spring pin to hold the original sight in place.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw

Red Dot Fitment:

• Vortex Defender Series (Defender XL requires the screws provided by Vortex)
• Vortex Venom (Enclosed Red Dot)
• OSight SE
• Bushnell RXS-100
• Crimson Trace CTS-1500
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*
• Holosun EPS-RD*
• Holosun EPS-Carry-GR*
• Holosun EPS-Carry-RD*
• Jpoint
• Leupold Delta Point Pro
• Optima
• Redfield Accelerator
• Shield RMS
• Shield RMSc
• Shield SMS
• Sig Romeo Zero

Simply remove the rear sight on your gun and replace it with our mount in order to mount your Leupold DeltaPoint Pro, JPoint, Redfield Accelerator, or Optima red-dot sight. You can take our mount off and replace your rear sight at any time. Mounting hardware included.

Installation Instructions
- Remove the rear sight*
- Install the EGW Sight Mount in the dovetail
- Tighten set screw (if applicable)
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mountwill make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque mounting screws to 15in/lbs

WE RECOMMEND THIS PLATE BE INSTALLED BY A QUALIFIED AND COMPETENT GUNSMITH.

Modification of your firearm may nullify the manufacturer's warranty.
This product should be installed and checked by a qualified gunsmith.
No liability is expressed or implied for damage or injury which may result from improper installation or use of this product.