This mount fits:
HK VP9 Optics Ready Models

(This mount is comparable to the HK VP9 #4 Plate)

The screws that come with your slide to mount the plate to the slide may be reused. They are also available for purchase from the drop down above. HK recommends replacing the plate mounting screws after 2,000 rounds. HK recommends torquing the screws for the plate to 2Nm or 17.7 in/lbs.

Material: 7075 Aluminum
Coating: Matte Black Hardcoat
Overall Length: 1.604"
Overall Width: .99"
Mounting Hardware: (2) 6-32 Button Head Screws, (1) 6-32 X 3/16 Set Screw

Red Dot Fitment:

   
• Vortex Defender Series
• OSight SE
• Bushnell RXS-100   
• Crimson Trace CTS-1500   
• Holosun 407K*
• Holosun 407k-GR
• Holosun 507K*
• Holosun 507k-GR
• Holosun EPS-GR*   
• Holosun EPS-RD*   
• Holosun EPS-Carry-GR*   
• Holosun EPS-Carry-RD*   
• Jpoint   
• Leupold Delta Point Pro   
• Optima   
• Redfield Accelerator  
• Shield RMS   
• Shield RMSc   
• Shield SMS   
• Sig Romeo Zero

Simply remove the plate on your gun and replace it with our mount in order to mount your red-dot sight. You can take our mount off and replace your rear sight at any time. Red dot mounting hardware included.

Installation Instructions
- Remove the rear cover plate
- Install the EGW sight mount and torque the mounting plate screws
- Place the red dot sight on the EGW Sight Mount
(placing a small piece of paper between the red dot sight and the sight mount will make for easier removal and will keep Loctite off of the red dot sight.)
- Apply blue Loctite to the provided mounting screws
- Torque red dot mounting screws to 15in/lbs