Through our years of experience building guns, we were able to come up with a lot of improvements over the various beavertail offerings available today. Our improvements include the following:

- Our beavertail is wider than the frame @ .770 (allowing you to the blend the beavertail to the frame, and not the other way around)
- The pin hole is reamed to .158 (improving fit and ambi's function)
- Lower bottom grip surface (no need to break into the thumb safety hole)
- Longer bottom (less gap between beavertail and main spring housing)
- Wider bottom to "fill" frame better (around .617)
- Bottom radius smaller to better fill frame radius cuts
- .308-.309 wide to fit frame ears snug (no rattles)
- The pad is fuller and blank allowing for artist's interpretation
- No pits, as the part is machined from bar stock
- Radius is .220
- Bottom angle better matches main spring housing again for less gap

Beavertail FAQ's can be found here.