EGW standard SS spring plug is included.

This kit does not include recoil springs, but they can be purchased separately.

This tungsten guide rod should be checked by a gunsmith familiar with the 1911 design. It may require minor fitting to contact the frame evenly. Failure to do so may lead to premature wear and/or breakage which will not be covered under warranty.

The head of the guide rod has smooth beveled edges to make for a seamless look.

It is necessary to remove the front half of the guide rod to disassemble the gun.

Check for fit in 3 areas:
(1) Barrel feet should not contact head
(2) Where guide rod rests against frame
(3) Back surface of slide/dustcover is flat and even.